Cabletron Systems CSX1000 - Manual (Page 262)

USER’S GUIDE
262 CyberSWITCH
Routers shown in the diagram above. Sample configurations for the objects in the above network
diagram are as follows:
Note: The DHCP Server must have a route specified to get back to the DHCP-enabled router
Ruby, or use Alex as its default gateway.
Configuration for IP Router "Alex" Configuration for IP Router "Ruby"
System Information:
System Name = Alex
System Password = stone System Information:
System Name = Ruby
System Password = rubble
Security Level = Device Level (On-node
Device Database, PAP security) Security Level = Device Level (On-node
Device Database, PAP security)
Bridging disabled Bridging disabled
IP enabled (router mode)
I/F = LAN (192.168.1.168)
I/F = WAN (192.168.10.168)
Static Route = (dest) 204.157.42.0
(next hop) 192.168.10.1 IP enabled (router mode)
I/F = LAN (204.157.42.168)
I/F = WAN (192.168.10.1)
DHCP enabled
Relay Destination # 1 = 192.168.1.5
(interface = “N/A”)
Hop Count Threshold = 4 DHCP enabled
Relay Destination # 1 = 192.168.10.168
(interface = “N/A”)
Hop Count Threshold = 4
Device = “Ruby”
ISDN Line Protocol = PPP
Dial Out Phone # = 5311
PAP Password = “rubble”
IP Address = 192.168.10.1
IP Routing = enabled
Make calls for IP data = enabled
Bridging = disabled Device = “Alex”
ISDN Line Protocol = PPP
Dial Out Phone # = 5411
PAP Password = “stone”
IP Address = 192.168.10.168
IP Routing = enabled
Make calls for IP data = enabled
Bridging = disabled