Cabletron Systems CSX1000 User Manual
Page 161
Workgroup Remote Access Switch 161
C
ONFIGURING
D
EVICE
L
EVEL
D
ATABASES
On-node Device Entries
a.
Enable or disable IPX routing.
b.
If you enable IPX routing and want dial-out capabilities to this device, enable the Make Calls
feature.
c.
If you enable IPX routing, you may enable or disable IPXWAN protocol.
d. If you enable IPX routing, select IPX Routing Protocol. Select a routing protocol of none, RIP/
SAP, or Triggered RIP/SAP. When you select Triggered RIP/SAP, you will need to identify
the WAN peer type as either active or passive.
e.
You may also select Spoofing Options. Make changes to default spoofing setup, if desired.
Refer to
and
for more information.
11. To enter any needed AppleTalk information for your device, select AppleTalk from the Device
Table Menu. The following screen will be displayed:
a.
Press 1 at the above menu, then follow the on-screen instructions to enable AppleTalk
routing for the device.
b.
Press 2 at the above menu to enter the device’s AppleTalk address. If the device is over an
unnumbered link, enter 0.0. If the device is over a MAC dial-in port, you may either enter
an address, or leave the value at “none”.
c.
Press 3 at the above menu, then follow the on-screen instructions to configure whether or
not dial out to this device is allowed for this device.
d. Press 4 at the above menu to specify an AppleTalk routing protocol the system should use
with this device. The options are None or RTMP. Currently RTMP is only supported for
devices who will be dialing into the CyberSWITCH via a MAC dial-in port.
Note:
If you are configuring a device for AppleTalk Remote LAN, leave the above AppleTalk
information at the default values (DISABLED, None, DISABLED, None).
Refer to
AppleTalk Configuration Elements
for more information.
12. To enter any needed bridge information for this device, select Bridge from the Device Table
Menu. The following screen will be displayed:
You may enable or disable bridging for this device. If this device is to use a Remote LAN
interface or Remote LAN port, enable bridging. If you want dial out capabilities to this device,
enable Make calls for Bridge data.
Device AppleTalk Menu: (device = “DAN”)
1) AppleTalk Routing DISABLED
2) AppleTalk Address None
3) Make calls for AppleTalk data DISABLED
4) AppleTalk Routing Protocol None
Select function from above or <RET> for previous menu: 1
Device Bridging: (device = "DAN")
1) IP (Sub)Network number NONE
2) Bridging ENABLED
3) Make Calls for Bridge data NONE
4) IPX Remote LAN Network Number NONE
5) IPX Spoofing Options
6) AppleTalk Network Number NONE
Select function from above or <RET> for previous menu: