Cabletron Systems CSX1000 - Manual (Page 447)

Workgroup Remote Access Switch 447
S YSTEM M ESSAGES
System Message Summary
Error mapping WAN adapter # ’x’ into Host memory map
The configured memory location of the indicated WAN card conflicts with another WAN card or
device. Review the configuration for the indicated adapter.
Error opening file <file name>
Error opening file <file name>, section = <section name>
Error opening file <file name>, slot <slot # >
If seen repeatedly, contact your Distributor or Customer Support.
Error parsing old WAN (Direct Host) interface: bad format
The information contained in the WAN (Direct Host) interface is invalid. To correct, use CFGEDIT
to reconfigure the interface.
Error initializing WAN card: <WAN card Id>
The system could not initialize the specified WAN card during system initialization. Check the
WAN card installation and configuration. If the error continues, report the problem.
Error parsing old WAN (Direct Host) interface: LAN interface <LAN netif name> for specified port <port# >
already in use
This error may display after upgrading software which contains secondary IP addressing and an
“old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete any WAN (Direct Host)
interfaces on the problematic LAN port, and reconfigure them.
Error parsing old WAN (Direct Host) interface: no LAN interface for specified port <port# >
This error may display after upgrading software which contains secondary IP addressing and an
“old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete the problematic WAN
(Direct Host) interface. Afterwards, configure a LAN interface and then read the WAN (Direct
Host) interface.
Error parsing WAN (Direct Host) interface: no LAN interface for specified name <name>
The LAN network interface associated with this WAN (Direct Host) interface is not present. Use
CFGEDIT to delete the problematic WAN (Direct Host). Check configuration for the suspect LAN
interface; it most likely will not be there. Add LAN interface, then reconfigure the WAN (Direct
Host) interface.
Error opening file \system\ethernt2.bin
The LAN adapter executable file could not be opened. Check for proper software installation.
Error programming adapter # ’x’ hardware
The WAN card initialization subsystem encountered an error while attempting to program the
hardware on the indicated adapter. Restart the system and review the configuration for the
adapter. If the problem persists, the indicated adapter card may be faulty; contact your Distributor
or Customer Support.
Error reading file <file name>, section = <section name>
If seen repeatedly, the above message indicates a problem with your file system. Contact your
Distributor or Customer Support.
Error reading file \system\ethernet2.bin,section = <file type>
The specified section of the LAN adapter executable file could not be read. Check for proper
software installation.