Cabletron Systems CSX1000 User Manual
Page 362
USER’S GUIDE
362 CyberSWITCH
The steps to verify the operation of IP routing over a WAN interface are:
1.
Determine if a remote IP host can access the WAN interface of the CyberSWITCH over the
WAN connection. On the remote IP host, type:
ping 192.100.1.1
<return>
If the remote IP host successfully pings to the CyberSWITCH, then continue with the next step.
If the remote IP host CANNOT ping to the system, refer to
IP Routing Over a WAN Interface
in the Problem Diagnosis chapter.
2.
Determine if a remote IP host can access the LAN interface of the CyberSWITCH over the WAN
connection. On the remote IP host type:
ping 100.0.0.1
<return>
If the remote IP host successfully pings to the CyberSWITCH, then continue with the next step.
If the remote IP host CANNOT ping to the CyberSWITCH, refer to
in the Problem Diagnosis chapter.
3.
Determine if a remote IP host can access the local IP host through the system over the WAN
connection. On the remote IP host type:
ping 100.0.0.2
<return>
If the remote IP host successfully pings to the local IP host, then IP routing over WAN type
interface is operational. Repeat the above steps for each WAN type interface through which
you wish to get access.
If the remote IP host CANNOT ping to the local IP host, refer to
IP Routing Over a WAN Interface
in the Problem Diagnosis chapter.
192.100.1.1
100.0.0.1
100.0.0.0
Host A
100.0.0.2
Host B
192.100.1.3
ISDN
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-T
RX
TX
SERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4
CSX1200