Cabletron Systems CSX1000 - Manual (Page 518)

USER’S GUIDE
518 CyberSWITCH
sp
This command pertains to semipermanent connections. This command will list each
semipermanent device, as well as the connection status, initial data rate and current data rate
for each semipermanent device. The connection status will be one of the following:
C ONNECTED
The system is connected to the device at the initial data rate or greater.
O VERRIDDEN
The disc device command was issued on this device. The system will not attempt to call
again until a call device command is issued, or the system is rebooted.
N OT C ALLABLE
This device cannot be called. Check phone number, device type or existence of the device name
in the database.
R EJECTED
The remote device answered the system call, but rejected negotiations. The system stops calling
attempts until a
call device command is issued, or the system is rebooted.
T RYING
The system is attempting to call the device. Some connections may be up, but not at the initial
data rate.
status
Displays initialization, current status, and connection information, as well as any errors that
have been detected.
led status
Allows you to view a snapshot of LED information from a remote terminal. It displays a very
basic ASCII rendering of the front of the system you are accessing. Each one of the WAN LEDs
and the Service LED are labeled, and the state of each is indicated by an “O” for on, and a “.”
for off.
Note that if the B-channels on a line are flickering, you will only see the current state of the
flicker. The image could actually represent a busy system that has every channel active, but the
LEDs for all the channels just happen to be off the instant the “snapshot” was taken.
Refer to the LED Indicators chapter for a more detail description of the LED indicators.
time
Displays the current system time. This can be useful when viewing system messages or
statistics.
ver
Displays the version number of the software that is currently running on the system (II, III,
etc.). In addition, it displays all other custom information for this copy of the system software,
such as the platform, the installed resources, and the hardware resource revision information.
Note that T1_E1_PRI-1 indicates the PRI-23/30 adapter.