Cabletron Systems CSX1000 - Manual (Page 541)

Workgroup Remote Access Switch 541
S YSTEM C OMMANDS
IP Routing Commands
ip rip send
Used to send the IP RIP update messages to a particular interface on demand. The example
screen below demonstrates how you use this command.
ip rip stats
Displays global RIP statistics and also statistics for each configured RIP interface. Refer to RIP
Statistics , for a list of available statistics and their definitions.
ip route
Displays the current routing table. The meaning of each displayed field for a route entry is as
follows:
Destination
IP address for the destination network or host.
Subnet-Mask
Subnet mask value for the destination network or host. A value of 255.255.255.255 indicates
that this entry is for a specific IP host.
Next Hop
IP address or device name for the next hop router that provides access to the destination
network or the host.
Metric
Hop count to the destination network or the host.
T/P (Type/Protocol)
Type
The destination type is “R” for a remote network or host, and “L” for a locally connected
network or host.
Protocol
The mechanism used to determine the route. “L” is for local, “I” is icmp, and “R” is for RIP.
TTL
Time to Live for this route entry in seconds. This entry will expire after the specified number
of seconds. A value of 999 implies that the entry will not expire.
IF
The interface Id.
Age
The age of the route in seconds.
ip route <IP address>
Displays the routing information for the indicated device. The meaning of each displayed field
for a route entry is included in the above
ip route command explanation.
[System Name]> ip rip send 2.2.2.2
Sending IP RIP Update Message to Network 2.0.0.0