Appletalk routing initialization, Appletalk routing over the lan connection – Cabletron Systems CSX1000 User Manual
Page 405
Workgroup Remote Access Switch 405
P
ROBLEM
D
IAGNOSIS
AppleTalk Routing
A
PPLE
T
ALK
R
OUTING
I
NITIALIZATION
Problem:
The CyberSWITCH does not display the correct AppleTalk Routing Initialization messages.
Action:
1.
Check the system configuration. Make sure that the AppleTalk feature is enabled for the
system.
A
PPLE
T
ALK
R
OUTING
O
PERATIONAL
OVER
THE
LAN
CONNECTION
Problem:
No zones appear in the Mac’s Chooser.
Action:
1.
Verify that the AppleTalk LAN port that Local Mac is attached to is in up state by entering the
following console command:
atalk port
If the command shows the port is not in up state, wait for a couple of minutes and repeat this
step.
2.
Check to see if the LAN connection of the port is operational. If the LAN connection is not
operational, then correct the problem.
3.
If you are using Classic Networking, verify that EtherTalk is used on the Local Mac by opening
the Network control panel as shown below:
ISDN
CSX1200
"Site1"
CSX1200
"Site2"
Net Range: 10-11
Zone: Left Zone
Net Range: 20-21
Zone: Right Zone
Local Mac
Remote Mac
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-T
RX
TX
SERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-T
RX
TX
SERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4