Cabletron Systems CSX1000 User Manual

Page 457

Advertising
background image

Workgroup Remote Access Switch 457

S

YSTEM

M

ESSAGES

System Message Summary

[IP Host] Security Rejection - Invalid Security ID <Id string>
The system has received an IP Host Id, <Id string>, from a remote device that is not configured in
the Device List. The system has rejected the incoming call. Verify that the IP Host ID in the Device
List information is identical to the IP Host Id configured in the remote device.

[IP Host] Security Rejection - Security ID cannot be validated with Authentication Server
The System authentication type is configured to obtain device information off-node, for example
from a RADIUS server; however, such transactions are not yet supported when IP Host ID Security
is enabled.

[IP RIP] All network interfaces used
All RIP interface data structures are in use. No RIP information will be sent to any additional
interfaces. Contact your Distributor or Customer Support.

[IP RIP] Buffers allocated
The RIP successfully allocated the UDP buffers needed to transmit RIP packets.

[IP RIP] Initialization failed, unable to allocate buffers
The RIP initialization was not completed. The machine contains insufficient memory to allocate the
UDP buffers needed to transmit RIP packets. Contact your Distributor or Customer Support.

[IP RIP] RIP Protocol Initialization successful
The RIP protocol was successfully initialized.

[IP RIP] Route Maintenance Registration Failed
The IP RIP protocol was unable to register with the IP routing table notification system. Any
dynamic changes of the routing table configuration will not be reflected in the RIP packets sent to
other routes. contact your Distributor or Customer Support.

[IP RIP] Send queue full
The RIP transmission queue has become full. This is not a normal occurrence. The machine should
be restarted. If this message is displayed again after the machine has been restarted, contact your
Distributor or Customer Support.

[IP RIP] Shutdown complete
The RIP protocol was successfully shutdown via Dynamic Management. No RIP routing
information will be transmitted or received. Any routes learned via RIP will soon expire.

[IP RIP] Unable to add host route <IP address>
A failed attempt was made to add the host route to the IP RIP routing table. The routing table can
have approximately 300 routing entries, and at this time, the routing table is full. The host route will
not be broadcast via RIP packets and therefore other routers will not be able to learn the route to
this device. You can use the packet capture commands to try to determine if a device is advertising
an unusual number of routes. If you are unable to track down the problem, contact your Distributor
or Customer Support.

[IP RIP] Unable to add route, routing table full
The IP RIP routing table is currently full, no new routes can be added. The routing table can have
approximately 300 routing entries, and at this time, the routing table is full. This could result in
possible unreachable destinations. You can use the packet capture commands to try to determine
if a device is advertising an unusual number of routes. If you are unable to track down the problem,
contact your Distributor or Customer Support.

Advertising
This manual is related to the following products: