Cabletron Systems CSX1000 - Manual (Page 557)

Workgroup Remote Access Switch 557
S YSTEM C OMMANDS
UDP Commands
trace x25 [on/off]
Enables or disables the X.25 packet tracing option. This feature displays up to 15 octets of the
packet. To display the log file, issue the
dr console command. This option is initially disabled.
wan fr-ietf trace [on/off] [in/out] [device/fr_accessname_dlci] [prot]
Enables or disables the tracing of incoming and out going frame relay IETF packets. This
feature displays the direction of the packet, the device or PVC name, the line protocol, and up
to 15 octets of the packet. To display the log file, issue the
dr console command. This option is
initially disabled.
UDP C OMMANDS
UDP (User Datagram Protocol) provides a datagram mode of communication for delivery of
packets to a remote or on-node device. When the system’s IP operating mode is enabled, the
following UDP commands are available:
udp conns
Displays the current UDP connection status.
udp stats
Displays the current system UDP statistics. Refer to UDP Statistics , for a list of available
statistics and their definitions.
U
SER
L
EVEL
S
ECURITY
C
OMMANDS
The following console commands are available to provide information on the authentication
servers for user level security. They may be used to diagnose the following problems with:
•
connections to an off-node authentication server
• CyberSWITCH configuration
• authentication server user database entries
sentry log
This command acts as a toggle switch, enabling or disabling user authentication rejection
messages. If enabled, authentication rejection messages (identifying users who generated the
messages) are written to the log file. To display the log file, issue the
dr console command. This
option is initially disabled.
sentry status
Displays current Sentry status. This includes whether or not trace is enabled, as well as the
status and port number of each authentication server on the system.
sentry tacacs
Attempts an authentication session using TACACS. The system will report whether the
authentication attempted was successful or rejected.
sentry radius
Attempts an authentication session using RADIUS. The system will report whether the
authentication attempted was successful or rejected.