Cabletron Systems CSX1000 - Manual (Page 429)

Workgroup Remote Access Switch 429
S YSTEM M ESSAGES
System Message Summary
1 port LAN Adapter, operating in remote mode only
This is an initialization message. It identifies the Ethernet adapter type (Ethernet-1), and operating
mode. Remote bridging is supported.
2 port LAN Adapter, operating in local and remote mode
This is an initialization message. It identifies the Ethernet adapter type (Ethernet-2), and operating
mode. Both local and remote bridging are supported.
aarp found duplicate AppleTalk address <AppleTalk Address> @ <MAC address>
The address resolution protocol found duplicate AppleTalk addresses for this AppleTalk network.
Check the configuration for the AppleTalk ports’ network range/number.
Abnormal response rcvd: <state msg reason cc state>
An unexpected message was received from a WAN interface card. The <parameters> included are
for problem reporting purposes only. If the system fails to operate normally, or the warning
continues to occur, contact your Distributor or Customer Support.
A call has exceeded the configured maximum duration
A call has been up longer than the amount of time configured. The next log message will inform
the user whether or not the call has been taken down.
ACE authentication is not available. You must first ENABLE ACE user level authentication.
An attempt was made to configure the Terminal Server Security for ACE and ACE was not
configured on the CyberSWITCH.
Adapter does not respond: adapter # ’x’
The WAN card initialization subsystem encountered an error on the indicated adapter. Restart the
system. If the problem persists, the indicated adapter card may be faulty and you should contact
your Distributor or Customer Support.
Adapter # ’x’ failed to initialize
The operational software on the indicated adapter card failed to signal that initialization was
completed. Restart the system. If the problem persists, the indicated adapter card may be faulty and
you should contact your Distributor or Customer Support.
Adapter # ’x’ failed to respond from bootstrap
The WAN card initialization subsystem encountered an error on the indicated adapter while
downloading the bootstrap program. Restart the system. If the problem persists, the indicated
adapter card may be faulty and you should contact your Distributor or Customer Support.
Adapter failed to respond while programming: adapter 'x'
The WAN card initialization subsystem encountered an error on the indicated adapter while
programming the hardware. Restart the system. If the problem persists, the indicated adapter card
may be faulty and you should contact your Distributor or Customer Support.
Administrative Session using ACE does not support password change.
Passwords may only be changed via the ACE Server administrator initiation. During an
administrative login, the user attempted to change password. ACE only supports password change
initiated by ACE Server administrator.
AppleTalk routing initialized successfully.
This message is posted when the system AppleTalk routing feature has initialized successfully.