Cabletron Systems CSX1000 User Manual
Page 162
USER’S GUIDE
162 CyberSWITCH
For IP Remote LAN networks, you must explicitly configure the IP (Sub)Network number.
For IPX Remote LAN networks, you may configure the IPX external network number, or you
may leave the value at NONE. The IPX Spoofing Options for IPX Remote LAN devices are not
available at this time. For additional information, please refer to the Configuring IPX chapter,
.
For AppleTalk Remote LAN networks, you may configure the AppleTalk network number/
range (used on the Remote LAN for this device), or you may leave the value at NONE.
13. To enable per-device compression information, select Compression from the Device Table
Menu. The following menu will then be displayed:
a.
If compression is not already enabled for this device, press 1 and follow the onscreen
instructions to change the configuration to enabled.
b.
If the remote device does not use 1 as the starting PPP STAC-LZS sequence number, press
2 to enter a new value for the starting sequence number.
U
SING
M
ANAGE
M
ODE
C
OMMANDS
device
Displays the current Device Table. Included in this display is each device’s ID and name. After
the list has been displayed, you may enter a specific device Id to display detailed information
for that device.
device add
Allows you to add a device entry to the Device Table. You will be prompted for the device
name and device type. The rest of the information you will be prompted for will depend upon
the device type you are configuring, and the security options that are enabled. Note that the
device name is case sensitive. You are prompted for the device information similarly to the way
you are prompted by CFGEDIT. Refer to the above section,
for instructions.
device change
Allows you to change information for a specific device entry. The current device table will be
displayed. Enter the device Id or device name of the entry you wish to change. Note that the
device name is case sensitive. Step through the configuration information displayed for the
device, pressing <return> if you wish to keep the originally configured information, and
entering new information where you want it changed. For a definition of the configuration
elements, refer to the section,
On-node Device Database Configuration Elements
.
device delete
Allows you to delete a device entry for a specific device. The current device table will be
displayed. Enter the device Id or device name of the device whose device entry you wish to
delete. Note that the device name is case sensitive.
Device Compression Menu: (device = "DAN")
1) Compression ENABLED
2) Starting PPP STAC-LZS Sequence Number 1
Select function from above or <RET> for previous menu: