Cabletron Systems CSX1000 - Manual (Page 512)

USER’S GUIDE
512 CyberSWITCH
If you are using an CyberSWITCH as your local ISDN device, you can either configure an
outbound phone number for the CyberSWITCH site or use the call peer command to
call the CyberSWITCH without configuring the phone number for the device explicitly.
Modify the switch type and the line type (point-to-point or point-multipoint) to match your
local ISDN line.
2. Configure your TCP/IP stack on your PC or similar LAN based TCP/IP device with the
following information:
IP Address:an unused IP address on your local LAN
Default Gateway:the IP address of the local ISDN device
If you have not configured the phone number of the remote CyberSWITCH in the local
ISDN device, you must call it manually. On a local CyberSWITCH, use the
call peer
<phone number> command.
3. Telnet to 2.2.2.2 on your local TCP/IP device or PC. This is the unconfigured remote
CyberSWITCH.
You can now configure the remote CyberSWITCH.