Cabletron Systems CSX1000 - Manual (Page 244)

USER’S GUIDE
244 CyberSWITCH
C ONFIGURING TCP
If you have selected TCP as your IP protocol, a screen similar to the following is displayed. Note
that the following TCP defaults constitute a wild card match for any TCP packet:
1. Select TCP Source Port. Note that the ports are specified in terms of an operator.
2. Select a comparison operator.
3. If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-range
and lower-range values. If you have chosen a comparison operator other than “RANGE”, you will be
prompted for a specific TCP port number.
4. Select TCP Destination Port. Note that the ports are specified in terms of an operator.
5. Select a comparison operator.
6. If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-range
and lower-range values. If you have chosen a comparison operator other than “RANGE”, you will be
prompted for a specific TCP port number.
7. Select TCP Control.
8. Specify a control value (any, established, or not established).
C ONFIGURING UDP
If you have selected UDP as your IP protocol, a screen similar to the following is displayed. Note
that the following UDP defaults constitute a wild card match for any UDP packet:
1. Select UDP Source Port. Note that the ports are specified in terms of an operator.
2. Select a comparison operator.
PACKET TYPE "Type_One":
1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.0
2) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.0
3) IP Protocol EQUAL TCP
4) TCP Source Port RANGE 0 - 65535
5) TCP Destination Port RANGE 0 - 65535
6) TCP Control ANY
Select function from above or <RET> for previous menu:
PACKET TYPE "Type_One":
1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.0
2) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.0
3) IP Protocol EQUAL UDP
4) UDP Source Port RANGE 0 - 65535
5) UDP Destination Port RANGE 0 - 65535
Id of the item to change, <RET> to accept changes or <CTRL-C> to cancel