Cabletron Systems CSX1000 - Manual (Page 511)

Workgroup Remote Access Switch 511
R EMOTE M ANAGEMENT
Remote Installation with USER2
R
EMOTE
I
NSTALLATION WITH
USER2
The CyberSWITCH is delivered with a default configuration. This default configuration includes a
configured device, USER2. Advanced users may use the default configuration to perform the
configuration of a remote CyberSWITCH. The network must be setup as illustrated below to take
advantage of remote configuration through USER2.
To begin, you must have an ISDN device with a WAN and LAN connection (we recommend an
CyberSWITCH), a simple two node LAN, and a computer with a TCP/IP stack with a Telnet client
which you can reconfigure.
After you have your setup complete, you must:
1. Minimally configure the remote CyberSWITCH:
a.
switch type (US only)
b. point-to-point or point-multi-point line
c. SPIDS for DMS-100 and NI-1 lines
2. Configure your local ISDN device using the following information:
Name:USER2
Secret:USER2
Security:CHAP only
WAN IP:2.2.2.3
LAN IP:an unused IP address on your local LAN
Static Route:to 1.1.1.1 (mask 8), next hop 2.2.2.2
single user:
Name:LINK
Secret:LINK
Device Type:PPP
IP Address:2.2.2.2
TCP / IP
Client
User 2
Using
default configuration
ISDN
POWER SERVICE TX RX 10BASE - T LAN B-CHANNELS E1 ONLY
B2 B4 B6 B8 B26 B28 B22 B24 B18 B20 B14 B16 B10 B12 B30 L1 B1 B3 B5 B7 B25 B27 B21 B23 B17 B19 B13 B15 B9 B11 B29 B31 E1 D T1 D POWER SERVICE TX RX 10BASE - T LAN B-CHANNELS E1 ONLY
B2 B4 B6 B8 B26 B28 B22 B24 B18 B20 B14 B16 B10 B12 B30 L1
B1 B3 B5 B7 B25 B27 B21 B23 B17 B19 B13 B15 B9 B11 B29 B31 E1 D T1 D