Call detail recording commands, Call restriction commands – Cabletron Systems CSX1000 User Manual
Page 534
USER’S GUIDE
534 CyberSWITCH
with the name Schultz, and a device configured with the name Schmidt, this message
would be displayed. You would then need to enter at least
call device Schu
to
successfully initiate a call to the device Schultz.
Re-enter the name, or <RET> to cancel
The device name must be re-entered.
Unable to prompt for device name at this time
Indicates that the
call
command would prompt you for a device name, but the necessary
resources are not available. The recommended actions are as follows:
1.
If possible, enter the device name on the command line.
2.
If the device name cannot be entered from the command line (for example, the device
name contains command line delimiters of a space, a comma, a colon, or a tab), the
device can wait for a few minutes and see if any resources become available.
3.
If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,
please inform your service representative of the occurrence.
C
ALL
D
ETAIL
R
ECORDING
C
OMMANDS
The following commands are used to monitor and verify the call detail recording (CDR) feature.
cdr stats
Display the CDR statistics. Refer to
Call Detail Recording Statistics
, for the available statistics and
corresponding definitions.
cdr stats clear
Clears the CDR statistics; setting them all to zero.
cdr verify
Generates a sample message to all servers that have been configured for CDR. A message
similar to the following will be displayed:
<system name> CDR VERIFY 1 of 1
Refer to
for the commands that will allow you to display or erase CDR log reports.
C
ALL
R
ESTRICTION
C
OMMANDS
When the Call Restriction feature is enabled on the CyberSWITCH, the following command is
available through the administration console:
cr stats
Displays the current Call Restriction statistics. Refer to
, for a list of
available statistics and their definitions.
Other Call Restriction commands are available through Dynamic Management. Refer to
for these commands.