Cabletron Systems CSX1000 - Manual (Page 556)

USER’S GUIDE
556 CyberSWITCH
session information for a TFTP session that has terminated. The screen below illustrates the use
of this command.
tftp stats
Displays the current TFTP related statistics. Refer to TFTP Statistics , for a list of available
statistics and their definitions.
T
RACE
C
OMMANDS
Note: For an explanation regarding the output resulting from the family of trace commands, refer
to the Trace Messages chapter.
The following commands are used to enable and disable trace reporting information:
trace ipxwan [on/off]
Enables or disables the IPXWAN tracing option, which tracks all packets which are received or
sent out using IPXWAN protocol, and places this information in the system log. To display the
log file, issue the
dr command. This option is initially disabled.
trace lapb [on/off]
Enables or disables the LAPB data link information packet tracing option. This feature displays
up to 15 octets of the packet. To display the log file, issue the
dr console command. This option
is initially disabled.
trace [on/off]
Enable or disables the call trace information reports. If enabled, you can then view the logged
call trace information by issuing the
dr command. For details on call trace messages, refer to
the chapter titled Trace Messages .
trace ppp [on/off]
Enables or disables the tracing of incoming and outgoing PPP packets. If enabled, you can view
the trace PPP information by issuing the
dr command.
> TFTP SESSION
Id Sess-Id Local file Type/Mode Bytes Xmit Retries
----------------------------------------------------------
1 5 temp.txt Client/Put 12752 1
2 6 tmp Server/Get 423 0
3 7 text.txt Server/Put 8481 0
Select the ID of the TFTP Session to display or <RET> to cancel? 2
TFTP Session ID: 6
Type: Server
Mode: Get
Local Address: 190.5.6.8 (UDP Port: 5001)
Local File: c:\tmp
Remote Address: 190.5.6.11 (UDP Port: 5011)
Remote File: N/A
Transfer Mode: netascii
Bytes Transferred: 935
Bytes Remaining: 1145723
Total Retries: 0