Cabletron Systems CSX1000 - Manual (Page 90)

USER’S GUIDE
90 CyberSWITCH
U SING M ANAGE M ODE C OMMANDS
resource
Displays the current resource configuration.
R ESOURCE C ONFIGURATION E LEMENTS
R ESOURCE T YPE
The type of adapter (resource) that plug into the system. WAN adapters are the physical interface
for the attachment of lines (i.e., connections) to your system.
R ESOURCE S LOT
The slot number into which the resource is plugged.
I NTERNAL S WITCH T YPE
For ISDN resources (BRI and PRI) only. The switch type you wish to configure.
R EGION
For NET3 and NET5 switchtypes. When configuring switches, first identify the region of operation,
and then the country.
C OUNTRY
For the NET3 and NET5 switchtypes. The country in which the system is operating.
G ENERIC N UMBER
For PRI_4ESS primary rate switch type only. The software load (generic # ) the switch is running.
S YNCHRONIZATION T YPE
For Primary adapters only. Every framed transmission line requires a clock source from which it
must derive the appropriate bit timing and channel timing relative to the start of a frame. For most
CPE gear, the clocking is derived from the received signal and the transmission clock is thus a
“slave” to the network. However, if the line is to provide its own clocking, it must derive a clock
from an internal source rather than a received signal. The line is then a “master” clock source.
R ESOURCE B ACKGROUND I NFORMATION
The basic rate (BRI) resource directly terminates a standard USOC RJ45 connector. It is supplied
with a standard S/T interface. A U interface option is not available for this adapter. The BRI
resource supports 1 or 4 connections/ports depending on which option you purchase. It provides
support for the following switch types:
•
NTT
• 5ESS
• DMS100
• NI1
• 1TR6
• NET3
• Definity
• Legend
• TS0-13