Comtech EF Data DT-4500-A Series - Manual (Page 126)

DT-4500-A Series Downconverters Revision 1
Appendix A MN-DT4500A
A–16
A.7.2.4 Mute
The default RF mute state is ON (output is muted).
Command Details
Mute Output: <DEV/MUT_xxx'cr' xxx = ON or OFF
Confirmation: >DEV/MUT_xxx'cr''lf']
Retrieve Mute Status: <DEV/MUT_'cr'
Confirmation: >DEV/MUT_yyy'cr''lf']
yyy = ON/OFF/COLD
A.7.2.5 Carrier Mute Mode
The carrier mute mode determines the mute state of the unit during frequency changes. The
default carrier mute mode state is OFF (output is muted during frequency changes).
Command Details
Mute Mode: <DEV/CMM_xxx'cr' xxx = ON or OFF
Confirmation: >DEV/CMM_xxx'cr''lf']
Retrieve CMM Status: <DEV/CMM_'cr'
Confirmation: >DEV/CMM_xxx'cr''lf']
A.7.2.6 Redundant Mute Mode
The redundant mute mode determines how the backup unit handles the mute state during a
redundant switchover condition. If the redundant mute mode is ON then the backup unit’s mute
state will be the same as the primary unit that it is backing up. Otherwise, if the redundant mute
mode is off the backup unit will unmute its output any time a redundant switchover occurs.
The default redundant mute mode state is OFF (backup unit’s output automatically unmutes
when a redundant switchover occurs).
Command Details
Set CRM: <DEV/CRM_xxx'cr' xxx = ON or OFF
Confirmation: >DEV/CRM_xxx'cr''lf']
Retrieve CRM: <DEV/CRM_'cr'
Confirmation: >DEV/CRM_xxx'cr''lf']