Operating the powermax65 or powermax85, Operating the powermax65 or powermax85 -6, Powermax – Hypertherm Powermax65 Service Manual Rev.1 User Manual

Page 108

Advertising
background image

OperatiOn

4-6

powermax

65/85 Service Manual

Operating the Powermax65 or Powermax85

Follow the steps below to begin cutting or gouging with the Powermax65 or Powermax85.

Connect the electrical power, gas supply, and torch lead

For information on connecting the proper power cord with plug to the power supply, refer to Section 2, Power Supply

Setup.

Plug in the power cord and connect the gas supply line. For more information about the electrical requirements and the

gas supply requirements of the Powermax65 and Powermax85, see Section 2, Power Supply Setup. To connect the

torch, push the FastConnect

TM

connector into the receptacle on the front of the power supply You will attach the work

lead in the next section.

Power cord with

appropriate plug

Work lead

Torch lead

Gas

supply line

Advertising
This manual is related to the following products: