Attach the work lead to the power supply, Attach the work lead to the power supply -7, Powermax – Hypertherm Powermax65 Service Manual Rev.1 User Manual

Page 109

Advertising
background image

OperatiOn

powermax

65/85 Service Manual

4-7

Work lead

receptacle

on power supply

Keyed opening at

top of

receptacle

1. Insert the work lead connector into the receptacle on the front of the power supply.

Note: The receptacle is keyed. Align the key on the work lead connector with the opening at the top of the

receptacle on the power supply.

Caution: Make sure you use a work lead that is appropriate for your power supply.

Use a 65 A work lead with the Powermax65. Use an 85 A work lead with the

Powermax85. The amperage is marked near the rubber boot of the work lead

connector.

2. Push the work lead connector all the way into the receptacle on the power supply and turn clockwise, approximately

1/4 turn, until the connector is fully seated against the stop in order to achieve an optimal electrical connection.

Attach the work lead to the power supply

Caution: Ensure the work lead is fully seated in the receptacle to prevent overheating.

Advertising
This manual is related to the following products: