Hypertherm Powermax30 AIR Service Manual - Manual (Page 159)

Powermax30 AIR Service Manual 808850 159
6 – Power Supply Component Replacement
5. Rotate the coil into the power supply until the top of the coil points up.
6. Push-to-connect the other end of the heat exchange coil into the elbow fitting on the left side of the air filter.
7. Make sure all the hose and tube connections on the air filter are secure.
8. Complete the following procedures:
a. See Install the fan on page 156.
b. See Install the power supply cover on page 99.
c. Reconnect the power cord, and set the power switch to ON (I).
CAUTION!
If there are leaks in the gas supply hoses or connections:
 Cut speeds can decrease.
 Cut quality can deteriorate.
 Cutting thickness capability can decrease.
 Parts life can shorten.