Niveo Professional NNAS-R4 - Manual (Page 88)

NAS System
88 User Manual
Network Adaptor Configuration Options:
Device – Shows the network device name. eth0 is the device name for LAN0
gigabit port.
IP - Shows the current IP address of the network device. Configure the IP
address as necessary.
Gateway – Show the current IP address of the Gateway. To edit, enter the
Gateway IP address.
Subnet Mask - Shows the current subnet mask setting. To edit, type in the
new subnet mask number.
MTU - The MTU size (Maximum Transmission Unit) in bytes. To modify the
MTU size for this interface, select the new MTU size. Options are: 1500
(default), 2000, 3000, 4000, 5000, 6000, 7000, 8000, and 9000.
MAC address – Shows the MAC address of network device.
Enable on Boot - If enabled, this adapter will be active when proNAS starts
up.
Dynamic IP (BOOTP/DHCP) - If checked, this specifies that this network
device will dynamically obtain an IP address from a Dynamic Host
Configuration Protocol (DHCP) server or from a Bootstrap Protocol
(BOOTP) server.
Default Gateway - If checked, the default gateway will be enabled in this
adapter. A default gateway is a local IP router that is used to forward
packets to destination beyond the local network. Only one default
gateway in the NAS can be enabled in a certain time.
Reset – Use this button to undo or clear any changes made.
Apply – Use this button to save the changes made.
Create Trunking – Use this button to configure network trunking.