Rainbow Electronics W90P710CDG - Manual (Page 192)

W90P710CD/W90P710CDG
- 192 -
Continued.
BITS DESCRIPTION
[19] POCIC
PortOverCurrentIndicatorChange
This bit is set when OverCurrentIndicator changes. Writing a '1' clears this bit.
Writing a '0' has no effect.
[18] PSSC
PortSuspendStatusChange
This bit indicates the completion of the selective resume sequence for the port.
0 = Port is not resumed.
1 = Port resume is complete.
[17] PESC
PortEnableStatusChange
This bit indicates that the port has been disabled due to a hardware event
(cleared PortEnableStatus).
0 = Port has not been disabled.
1 = PortEnableStatus has been cleared.
[16] CSC
ConnectStatusChange
This bit indicates a connect or disconnect event has been detected. Writing a '1'
clears this bit. Writing a '0' has no effect.
0 = No connect/disconnect event.
1 = Hardware detection of connect/disconnect event.
Note: If DeviceRemoveable is set, this bit resets to '1'.
[15:10] Reserved Reserved. Read/Write 0's
[9] LSDA
(Read) LowSpeedDeviceAttached
This bit defines the speed (and bud idle) of the attached device. It is only valid
when CurrentConnectStatus is set.
0 = Full Speed device
1 = Low Speed device
(Write) ClearPortPower
Writing a '1' clears PortPowerStatus. Writing a '0' has no effect
[8] PPS
(Read) PortPowerStatus
This bit reflects the power state of the port regardless of the power switching
mode.
0 = Port power is off.
1 = Port power is on.
Note: If NoPowerSwitching is set, this bit is always read as '1'.
(Write) SetPortPower
Writing a '1' sets PortPowerStatus. Writing a '0' has no effect.
[7:5] Reserved Reserved. Read/Write 0's
[4] SPR
(Read) PortResetStatus
0 = Port reset signal is not active.
1 = Port reset signal is active.
(Write) SetPortReset
Writing a '1' sets PortResetStatus. Writing a '0' has no effect.