Rainbow Electronics W90P710CDG - Manual (Page 310)

W90P710CD/W90P710CDG
- 310 -
Continued.
SLOT # BIT DESCRIPTION
19 - 4 PCM playback data for left channel
PCM LEFT
(slot 3)
3 - 0 This field should be cleared to 0
19 - 4 PCM playback data for right channel PCM RIGHT
(slot 4)
3 - 0 This field should be cleared to 0
The structure of input frame is shown as below:
Slot # 0 1 2 3 4 5 6 7 8 9 10 11 12
Content Tag
status
ADDR
status
DATA PCM
LEFT
PCM
RIGHT
Unused
Bits 0-15 19-0 19-0 19-0 19-0 159 - 0
The input frame data format is shown as following:
SLOT # BIT DESCRIPTION
15 Frame validity bit, 1 is valid, 0 is invalid.
14 - 3
Slot validity, but in W90P710, only bits 6-3 are used, bits 14-7 are
unused. Bit 3 is corresponding to slot 1, bit 4 is corresponding to slot
2, etc.. 1 is valid, 0 is invalid. The unused bits 14-7 should be cleared
to 0.
Tag
(slot 0)
2 - 0 This field should be cleared to 0.
19 This bit should be cleared to 0
18-12 Control register address echo which previous frame requested
11
PCM data for left channel request, it should be always 0 when
VRA=0 (VRA: Variable Rate Audio mode).
10 PCM data for right channel request (Same as Bit 11).
Status ADDR
(slot 1)
9 - 0 This field should be cleared to 0
19 - 4
Control register read data which previous frame requested. It should
be cleared to 0 if this slot is invalid.
Status DATA
(slot 2)
3 - 0 This field should be cleared to 0
19 - 4 PCM record data for left channel PCM LEFT
(slot 3)
3 - 0 This field should be cleared to 0
19 - 4 PCM record data for right channel PCM RIGHT
(slot 4)
3 -0 This field should be cleared to 0