B&B Electronics ADAM-6066 - Manual - Manual (Page 103)

93 Chapter 5
The Peer-to-Peer function is disabled by default. You can enable it and
choose the basic mode or advanced mode by click the Basic or Advanced
radio button in the Mode area. After you choose the mode, click the
Apply button. ADAM-6000 modules features Peer-to-Peer and GCL
function in the same hardware. (The GCL feature will be introduced in
Chapter 7) However, only one of them can be enabled at one time. If you
have enabled GCL function before and now choose to enable Peer-to-
Peer function, there will be one warning message asking you to disable
GCL function first. (Refer to section 7.2 for how to disable GCL). After
GCL function is disable, you can select Basic or Advanced mode for
Peer-to-Peer function.
• Basic Mode Configuration
When you choose the basic mode, the Status Display should look like the
Figure 5.21 below. You can define the target device by entering its IP
address into the Destination text box in the Basic (One to One) area.
Figure 5.21: Peer-to-Peer Basic Mode Configuration