B&B Electronics ADAM-6066 - Manual - Manual (Page 270)

ADAM-6000 Series User Manual 260
Figure C.14: System Shielding (2)
• Shield connection (2)
The previous diagram shows you that the fill soldering just makes an eas-
ier way for the signal.
C.4 Noise Reduction Techniques
• Isolate noise sources in shielded enclosures.
• Place sensitive equipment in shielded enclosure and away from com-
puter equipment.
• Use separate grounds between noise sources and signals.
• Keep ground/signal leads as short as possible.
• Use Twisted and Shielded signal leads.
• Ground shields on one end ONLY while the reference grounds are not
the same.
• Check for stability in communication lines.
• Add another Grounding Bar if necessary.
• The diameter of power cable must be over 2.0 mm
2
.
• Independent grounding is needed for A/I, A/O, and communication net-
work while using a jumper box.