B&B Electronics ADAM-6066 - Manual - Manual (Page 55)

45 Chapter 4
Assigning Addresses for ADAM-6052 Modules
Based on Modbus/TCP, the addresses of the I/O channels in ADAM-6000
modules are defined by a simple rule. Please refer to Appendix B.2.7 to
map the I/O address. All digital input channels in ADAM-6052 are
allowed to use as 32-bit counters (Each counter is consisted of two
addresses, Low word and High word). Users could configure the specific
DI channels to be counters via Windows Utility. (Refer to Section 5.3)
4.2.4 ADAM-6060
6-ch Digital Input and 6-ch Relay Module
ADAM-6060 is a high-density I/O module with a 10/100 base-T interface
for seamless Ethernet connectivity. Bonding with an Ethernet port and
webpage, ADAM-6060 offers 6 relay (form A) output and 6 digital input
channels. It supports contact as AC [email protected], and DC 30V@1A. DI
channels support input latch for signal handling, and can be used as 3
KHz counter and frequency input channels. Opposite to the intelligent DI
functions, the DO channels also support pulse output.
ADAM-6060 Specifications
• Communication: 10/100 Base-T Ethernet
• Supports Protocols: Modbus/TCP, TCP/IP, UDP, HTTP, ICMP, ARP
• Supports Peer-to-Peer and GCL (Refer to Section 5.3.4 and Chapter 7)
Digital Input
• Channels: 6
• Dry Contact:
Logic level 0: Close to Ground
Logic level 1: Open
• Wet Contact:
Logic level 0: 0 ~ 3 VDC
Logic level 1: 10 ~ 30 VDC
• Support 3 kHz counter input (32-bit + 1-bit)
• Support 3 kHz frequency input
• Support inverted DI status