B&B Electronics ADAM-6066 - Manual - Manual (Page 135)

125 Chapter 6
6.4.2 System Command Set
$aaM
Name
Read Module Name
Description Returns the module name from a specified module.
Syntax $aaM(cr)
$ is a delimiter character.
aa (range 00-FF) represents the 2-character hexadecimal
slave address of the ADAM-6000 module you want to
interrogate. (Always 01)
M is the Module Name command.
(cr) is the terminating character, carriage return (0Dh).
Command
Syntax Command Name Description
$aaM Read Module Name Return the module name from a
specified module
$aaF Read Firmware Version Return the firmware version
from a specified module
#aaVd-
bbbbdddddd
dd Write GCL Internal
Flags Write value(s) to GCL internal
flag(s) on a specific ADAM-6000
module
$aaVd Read GCL Internal
Flags Read all GCL internal flags'
values from a specific
ADAM-6000 module
Note: Command $aaM and $aaF support all ADAM-
6000 I/O modules.
Command #aaVdbbbbdddddddd supports
ADAM-6050, 6051, 6052, 6060, 6066.
Command #aaVd supports ADAM-6050, 6051,
6052, 6060, 6066.