B&B Electronics ADAM-6066 - Manual - Manual (Page 155)

145 Chapter 6
A is the Set Alarm Mode command.
h indicates alarm types (H = High alarm, L = Low alarm)
s indicates alarm modes (M = Momentary mode,
L = Latching mode)
(cr) represents terminating character, carriage return (0Dh)
Response !aa(cr) if the command was valid
?aa(cr) if an invalid operation was entered.
There is no response if the system detects a syntax error or
communication error or if the address does not exist.
! delimiter indicating a valid command was received.
aa represents the 2-character hexadecimal slave address of
the corresponding ADAM-6000 module.
(cr) represents terminating character, carriage return (0Dh)
Example command: $01C1AHL(cr)
response: !01(cr)
Channel 1 of the ADAM-6000 module at address 01h is
instructed to set its High alarm in Latching mode.
The module confirms that the command has been received.