B&B Electronics ADAM-6066 - Manual - Manual (Page 46)

ADAM-6000 Series User Manual 36
Assigning Addresses for ADAM-6024 Modules
Based on the Modbus/TCP standard, the addresses of the I/O channels in
ADAM-6000 modules you place in the system are defined by a simple
rule. Please refer to Appendix B.2.4 to map the I/O address.
4.2 Digital I/O Modules
4.2.1 ADAM-6050
18-ch Isolated Digital I/O Module
The ADAM-6050 is a high-density I/O module built-in a 10/100 based-T
interface for seamless Ethernet connectivity. It provides 12 digital input
and 6 digital output channels with 2000 VDC isolation protection. All of
the digital input channels support input latch function for important signal
handling. Meanwhile, these DI channels allow to be used as 3 KHz coun-
ter and frequency input channels. Opposite to the intelligent DI functions,
the digital output channels also support pulse output function.
ADAM-6050 Specifications
• Communication: 10/100 Base-T Ethernet
• Supports Protocol: Modbus/TCP, TCP/IP, UDP, HTTP, ICMP and ARP
• Supports Peer-to-Peer and GCL (Refer to Section 5.3.4 and Chapter 7)
Digital Input
• Channels: 12
• Dry Contact:
Logic level 0: Close to Ground
Logic level 1: Open
• Wet Contact:
Logic level 0: 0 ~ 3 VDC
Logic level 1: 10 ~ 30 VDC
• Supports 3 kHz counter input (32-bit + 1-bit)
• Supports 3 kHz frequency input
• Supports inverted DI status