B&B Electronics ADAM-6066 - Manual - Manual (Page 107)

97 Chapter 5
5. Repeat the step 1 to step 4 for another input channel. Continuously
repeat the configuration until you have configured all the input
channels which you want to create the mapping relationship. Click
the Apply list button to download all mapping configuration to the
target module. You can save all configurations in the mapping table
into a file by clicking the Save button. Or you can load previous
configuration from a file by clicking the Load button. If you click
the Refresh button, the real configuration on the source module
will be uploaded to your computer and you can see it in the map-
ping table.
In order to save setting time for the mapping configuration, you can copy
one channel setting to other channels, and then only change what needs to
change. You can do this by clicking the Copy to button, then a dialog
window will pop-up. Refer to the Figure 5.24 below for the image of that
dialog window.
Note: The mapping setting is only restored in memory of your
computer, and it will download to the target ADAM-6000
module after you click the Apply list button below the
mapping table. It is not suggested to download the map-
ping configuration immediately if you only complete set-
ting for one channel.
Note: We suggest you to download all channels mapping con-
figuration together at one time, instead of downloading
one-channel setting many times. The reason is that this
can save the times to use the flash memory on target
module and help to extend the flash memory life.