Figure 5.23: p-to-p advanced mode configuration, Figure 5.23:p-to-p advanced mode configuration – B&B Electronics ADAM-6066 - Manual User Manual
Page 106
ADAM-6000 Series User Manual
96
Figure 5.23: P-to-P Advanced Mode Configuration
Below are the steps to define the mapping relationship:
1.
Select the input channel by the Channel combo box in Source.
2.
Use Period time numeric control, Deviation enable (C.O.S) check
box (for analog modules) or Change of state (C.O.S) check box
(for digital modules), and Deviation Rate numeric control in the
Source area to define when to transfer the data for that channel.
The configuration operation is similar to Basic mode.
3.
Define the target device for that channel by entering its IP address
into the IP text box in the Destination area. Choose the correct
module name from the Name combo box, and choose the output
channel to receive the data by the Channel combo box.
4.
After you have completed all these configurations for this channel,
click the Config to list button. You can see your configuration for
that channel is displayed by the mapping table below the Source
and Destination area.