B&B Electronics ADAM-6066 - Manual - Manual (Page 52)

ADAM-6000 Series User Manual 42
Assigning Addresses in ADAM-6051 Modules
Based on Modbus/TCP standard, addresses of the I/O channels in
ADAM-6000 modules are defined by a simple rule. Please refer to
Appendix B.2.6 to map the I/O address. All digital input channels in
ADAM-6051 are allowed to use as 32-bit counters (Each counter is two
addresses, Low and High). Users could configure the specific DI chan-
nels to be counters via Windows Utility (Refer to Section 5.3).
4.2.3 ADAM-6052
16-ch Source Type Isolated Digital Input/Output Module
The ADAM-6052 is a high-density digital I/O module built-in a 10/100
based-T interface for seamless Ethernet connectivity. It provides 8 digital
input, 8 digital output channels. All of the digital input channels support
input latch function for important signal handling. The digital output
channels support the source type output. Meanwhile, these DI channels
allow to be used as 3 kHz counter and frequency input channels. Opposite
to the intelligent DI functions, the digital output channels also support
pulse output function.
ADAM-6052 Specifications
• Communication: 10/100 Base-T Ethernet
• Supports Protocol: Modbus/TCP, TCP/IP, UDP, HTTP, ICMP and ARP
• Supports Peer-to-Peer and GCL (Refer to Section 5.3.4 and Chapter 7)
Digital Input
• Channels: 8
• Dry Contact:
Logic level 0: Close to Ground
Logic level 1: Open
• Wet Contact:
Logic level 0: 0 ~ 3 VDC
Logic level 1: 10 ~ 30 VDC
• Supports 3 kHz counter input (32-bit + 1-bit overflow)
• Supports 3 kHz frequency input
• Supports inverted DI status