GE Industrial Solutions H5692448 Power Systems Infinity M1 (NE-M) - Manual (Page 22)

NE-M Installation Guide H5692448
CC848815325 r06 May 2013 22
Step Action
2
Apply labels onto PV/AC Partition as shown.
• Place “PV WIRING” label on the left (PV) side of partition.
• Place the “AC WIRING” label on the right (AC) side of
partition.
Figure 22 Partition Labels
3
Make space for the PV/AC Partition - Separate DIN rail Terminal
Blocks to make space for the PV/AC Partition.
Loosen screws securing all DIN spacer blocks to the left of the
Partition location specified in the site engineering instructions.
4
Slide Terminal Blocks and spacer to the left of the Partition
location to the left to allow installation of the PV/AC Partition.
Figure 23 Partition Insert
5
Install PV/AC Partition in the location specified in the site
engineering instructions.
Snap the Partition onto the DIN rail.
6
Slide the loosened Terminal Blocks and spacer block to the right
snugly against the Partition.
The Partition lower edge will be under the Terminal Block on its
left.
7
Tighten screws securing all DIN spacer blocks s to the left of the
Partition.