Burkert Type 8620 - Manual (Page 38)

mxCONTROL Type 8620
Page 38
→ Select the desired configuration file "XXX.cfg" for download into the „Type
8620 mxCONTROL“, press key "ENTER".
Download of the configuration file is running. If the download was successful, the
message "Successful" appears in the display.
→ Return to submenu by pressing key "EXIT".
→ Select associated parameter file “XXX.par”, press key "ENTER".
Download of the configuration file is running. If the download was successful, the
message "Successful" appears in the display.
→ Return to submenu by pressing key "EXIT".
→ Leave the submenu by pressing key “EXIT” (several times).
Remove the SD card by pressing against it.
11.2.2 Upload
For saving parameter/configuration files use the function “Upload”.
For the Upload process proceed as stated below
(see also the sample menu tree in the appendix 21.5.7)
→ Supply the „Type 8620 mxCONTROL“ with power
→ Insert an SD card (formatted with FAT16) into the interface (SD card slot)
under the hinged lid
→ Scroll in the main menu to the menu item “Up-/Download” (via “arrow” keys),
press key “ENTER”
→ Enter the correct password (via keys „+“ and „<-“)
( specialist password for configuration files,
operator or specialist password for parameter files)
→ Select “Upload” , press key “ENTER”
→ Select “Param-File” (operator or specialist level)
or „Config-File“ (for specialist level only) by pressing key “START”.
The device saves the file to the current folder (marked by a single dot ".") after
pressing the key "ENTER" or
scroll to another folder and press key "ENTER".
The device either uses the name of the last file loaded or creates a new internal
name
for the file by extending with “vXX”. (XX is running from 01 to 99).
To overwrite an existing file with new data, select the desired existing file, press
key “ENTER”. It appears a request for overwriting:
→ Press “YES” for overwriting the selected file,
→ press
“NO” for creation of a new file name (with extension vXX) or
→ press “EXIT” to stop/cancel the upload process
Comments in a downloaded xml-file will not be stored in „Type 8620 mxCONTROL“ – when
uploading a file no comments are included!
Up-/Download processes on SD-Card are only possible if Data Logging is disabled.