ARM Cortex R4F - Manual (Page 314)

Debug
ARM DDI 0363E Copyright © 2009 ARM Limited. All rights reserved. 11-45
ID013010 Non-Confidential, Unrestricted Access
11.8.2 Behavior of the PC and CPSR in debug state
The behavior of the PC and CPSR registers while the processor is in debug state is as follows:
• The PC is frozen on entry to debug state. That is, it does not increment on the execution
of ARM instructions. However, the processor still updates the PC as a response to
instructions that explicitly modify the PC.
• If the PC is read after the processor has entered debug state, it returns a value as described
in Table 11-41 on page 11-44, depending on the previous state and the type of debug
event.
• If the debugger executes a sequence for writing a certain value to the PC and subsequently
it forces the processor to restart without any additional write to the PC or CPSR, the
execution starts at the address corresponding to the written value.
• If the debugger forces the processor to restart without having performed a write to the PC,
the restart address is Unpredictable.
• If the debugger writes to the CPSR, subsequent reads from the PC return an Unpredictable
value, and if it forces the processor to restart without having performed a write to the PC,
the restart address is Unpredictable. However, CPSR reads after a CPSR write return the
written value.
• If the debugger writes to the PC, subsequent reads from the PC return an Unpredictable
value.
• If the debugger forces the processor to execute an instruction that writes to the PC and this
instruction fails its condition codes, the PC is written with an Unpredictable value. That
is, if the debugger forces the processor to restart, the restart address is Unpredictable.
Also, if the debugger reads the PC, the read value is Unpredictable.
• While the processor is in debug state, the CPSR does not change unless written to by an
instruction. In particular, the CPSR IT execution state bits do not change on instruction
execution. The CPSR IT execution state bits do not have any effects on instruction
execution.
• If the processor executes a data processing instruction with Rd==R15 and S==0, then
alu-out[0] must equal the current value of the CPSR T bit, otherwise the processor
behavior is Unpredictable.
Vector catch RA+8 RA+4 Vector address.
External debug request signal
activation RA+8 RA+4 Address of the instruction where the execution resumes.
Debug state entry request command RA+8 RA+4 Address of the instruction where the execution resumes.
OS unlock event RA+8 RA+4 Address of the instruction where the execution resumes.
CTI debug request signal RA+8 RA+4 Address of the instruction where the execution resumes.
a. This is the address of the instruction that the processor can execute first on debug exception return. The address of the
instruction that hit the watchpoint is in the WFAR.
Table 11-41 Read PC value after debug state entry (continued)
Debug event ARM Thumb Return address (RA a ) meaning