HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 130)

Creating dictionary map files
Application Agent automatically creates dictionary map files during installation. If you want the
dictionary map files to be created in a particular directory, or if you are installing Application Agent
in a cluster configuration, you must use one of the procedures explained in “
Creation in a non-cluster
configuration or on a backup server ” on page 130 to “ Creation in a cascade configuration for Exchange
database backup ” on page 135 to create the dictionary map files.
NOTE:
Unnecessary dictionary map files may remain after the removal of an old version of Application
Agent. If they do, remove the previous dictionary map files and then create new files.
This subsection describes the procedure for creating dictionary map files for different system
configurations.
Creation in a non-cluster configuration or on a backup server
In a non-cluster environment or on the backup server, dictionary map files are automatically created
at the following location when Application Agent is installed.
Application-Agent-installation-directory \DRM\db
If you use the dictionary map files automatically created during installation, you do not need to create
a new dictionary map files.
If you want to specify a directory and create dictionary maps file in it, create the dictionary map files
by using the procedure explained below.
To create dictionary map files in a user-specified directory:
1. Change the locations of the dictionary map files and backup catalog.
Add the
DRM_DB_PATH=
directory-name entry to the Application Agent configuration definition
file ( init.conf ). When editing the files, note the following points:
• Add the entry to the last line of the init.conf file.
• After directory-name, always enter a linefeed code.
• Specify a disk that is different from the volume to be backed up. Do not specify a disk that is
configured as part of the volume pair to be backed up.
• Specify a directory name by using an absolute path.
The following shows an example entry:
DRM_DB_PATH=H:\PTM
2. Create dictionary map files and a backup catalog on the disk.
Execute the drmdbsetup utility, as shown below.
PROMPT> Application-Agent-installation-directory \DRM\bin\util\drmdbsetup -i
When the dictionary map files and backup catalog are created, the following message appears:
All data files were created.
Preparation for using Application Agent 130