Rockwell Automation 1336T ControlNet Frn1.02 Rev 1.5 - Manual (Page 159)

6–17 Parameters
Publication 1336 FORCE–5.18 ––March, 1999
328 CntlNet Input 6
[CntlNet In 6]
CntlNet In 6 contains the seventh word or data
group from the PLC controller output image table.
The ControlNet scanner transfers the data to the
drive every rack scan. The ControlNet Adapter
Board can use this value directly. Other drive
functions can use this value through a configuration
link.
Parameter Number 328
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
329 CntlNet Input 7
[CntlNet In 7]
CntlNet In 7 contains the eighth word or data group
from the PLC controller output image table. The
ControlNet scanner transfers the data to the drive
every rack scan. The ControlNet Adapter Board can
use this value directly. Other drive functions can use
this value through a configuration link.
Parameter Number 329
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
338 SCANport Analog Input
[SP Analog In]
SP Analog In converts a +10V analog input value to
a +32767 value. You can then link this digital value
to one of the 1336 FORCE input parameters.
Parameter Number 338
Parameter Type Read Only, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Analog Input