Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 112)

Publication 1760-UM001D-EN-P - September 2005
4-52 Draw a Circuit Diagram with Pico
When activating several text displays, they are displayed automatically
every 4 s in succession. This process is repeated until:
• none of the display relays are set to 1
• stop mode is selected
• the Pico power is turned off
• the Ok or Del + Alt buttons are used to switch to a menu, or
• the text for D1 is displayed
The following applies to D1:
D1 is designed as an alarm text and takes precedence over all other
text displays. If D1 is activated, the text assigned to it is displayed
until:
• the coil D1 is reset to 0
• stop mode is selected
• the Pico power supply is switched off, or
• the Ok or Del + Alt buttons are used to switch to a menu
Text Entry
Text entry is only possible using PicoSoft version 2.1 and higher.
Character Set
All alphabetic characters in upper and lower case are allowed.
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
The following special characters are also allowed:
! “” # $% &’ ( ) * +, –. / 0 1 2 3 4 5 6 7 8 9
Examples
QUANTITY
QTY.0042
SETP0500 PCE
!COUNTING!
TEMPERATURE
A -010DEG.
I +018DEG.
HEATING
FUSE
FAULT
HOUSE 1
FAILED!
Counter with actual value
and setpoint Analog values scaled as
temperature values D1 as error message on
fuse failure