Wire terminals, Wire terminals -8, Required tools – Rockwell Automation 1760-xxxx Pico Controller User Manual User Manual
Page 32: Connect the serial cable
Advertising
Publication 1760-UM001D-EN-P - September 2005
2-8 Installation
Connect the Serial Cable
1. Remove the interface cover.
2. Using a screwdriver, push on the terminal latch.
3. Insert each wire into its designated terminal on the interface
connector.
4. Replace the interface cover.
Plug the other end of the cable into the Pico controller or I/O module.
Wire Terminals
Required Tools
Slot-head screwdriver (width: 3.5 mm, torque: 0.57 to 0.79 Nm [5 to 7
in-lb])
X5
Cable Wire Color Code
green
X4
white
X3
yellow
X2
brown
X1
gray
1
X5
X4
X3
X2
X1
2
3
4
1760-RM cable
Advertising