Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 146)

Publication 1760-UM001D-EN-P - September 2005
6-14 Pico System Settings
Pico only starts in the Run Mode if a memory module with a valid
program is inserted.
If the program on the memory module is different than the program in
Pico, the program from the card is loaded into the processor and the
processor starts in the RUN mode.
Switch to the System menu.
If Pico is protected by a password, the System menu is not available
until Pico is unlocked (see the section Unlock Pico on page 6-4).
Activation of Card Mode
If Pico displays Card Mode å , this means that when the power supply
is switched on, Pico will only start in Run mode if a memory module
with a valid program has been inserted.
1. Otherwise select Card Mode and press Ok.
Pico will start up with the program on the card.
2. Press Esc to return to the Status display.
Deactivation of Card Mode
1. Select Card Mode å .
2. Press Ok.
The Card Mode function is deactivated.
The Pico default setting is for display of the Card Mode menu, i.e. Pico
starts in Run Mode without the memory module when the power is
switched on.
Set Cycle Time Pico allows you to set the cycle time. The default setting is 00 ms.
Cycle time can only be set while Pico is in Stop mode.
1. Move to the System menu.
2. Select Cycle Time and press Ok.
The following menu appears.
3. Press Ok.
DEBOUNCE
P BUTTONS
RUN MODE
CARD MODE
DEBOUNCE
P BUTTONS
RUN MODE
CARD MODE
CYCLE TIME
P BUTTONS
RUN MODE
CARD MODE
CYCLE TIME
00 MS