Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 144)

Publication 1760-UM001D-EN-P - September 2005
6-12 Pico System Settings
2. Press Esc to return to the status display.
The P-Buttons are only active in the Status display. In this display, you
can use the P-Buttons to activate inputs in your circuit diagram.
Deactivate the P-Buttons
Select P BUTTONS and press Ok. The check mark is removed.
The P-Buttons are now deactivated. The P-Buttons are automatically
deactivated when deleting a circuit diagram in Pico.
Start-Up Behavior The start-up behavior is an important feature during the
commissioning phase. The circuit diagram which Pico contains may
not be completed or the system or machine may be in a state which
Pico is not permitted to control. The outputs should not be activated
when Pico is powered on.
Set the Start-Up Behavior
Pico models without a display can only be started in Run mode.
Requirement: Pico must contain a valid circuit diagram.
Enter the System menu. If Pico is protected by a password, the System
menu is not available until Pico is unlocked (see Unlock Pico on
page 6-4).
Specify in which operating mode Pico should start when power is
applied. MODE: RUN/STOP is a toggle menu. The menu always
displays the operating mode into which you can change.
Activate RUN Mode
The default setting for Pico is displayed as RUN MODE å . In other
words, Pico starts in Run mode when the power is applied.
If there is no check mark next to RUN MODE, select RUN MODE from
the menu and press Ok. Press Esc to return to the status display.
DEBOUNCE
P BUTTONS
RUN MODE
CARD MODE