Rockwell Automation 1760-xxxx Pico Controller User Manual User Manual
Page 80
Advertising
Publication 1760-UM001D-EN-P - September 2005
4-20 Draw a Circuit Diagram with Pico
In timing and counter relays, it is also possible to change the
switching behavior via the coil function.
ATTENTION
In Run mode, Pico processes the function relays after
a pass through the circuit diagram. The last state of
the coils is used for this.
Only use the coil of a function relay once.
Exception: The same coil can be used several times
when working with jumps.
Advertising