Connect the pico to the pc – Rockwell Automation 1760-xxxx Pico Controller User Manual User Manual
Page 130
Advertising
Publication 1760-UM001D-EN-P - September 2005
5-6 Save and Load Circuit Diagrams
Connect the Pico to the PC
1. Connect the PC cable to the serial PC
interface.
2. Insert the Pico plug in the open
interface.
3. Activate the status display on the
Pico.
Pico cannot exchange data with the PC while in any other
display mode.
Use PicoSoft to transfer circuit diagrams from your PC to Pico and vice
versa. Switch Pico to Run mode from the PC to test and monitor the
program.
ATTENTION
ELECTRICAL SHOCK HAZARD
Only use the 1760-CBL-PM02 cable with the Pico
units. Use of another cable may place the user in
danger of electrical shock.
Esc
Ok
1760-CBL-PM02
Advertising