Rockwell Automation 1760-xxxx Pico Controller User Manual - Manual (Page 28)

Publication 1760-UM001D-EN-P - September 2005
2-4 Installation
Minimum Spacing
Maintain spacing from enclosure walls, wireways, adjacent equipment,
etc. Allow 3 cm (1.18 in.) of space on all sides for adequate
ventilation, as shown:
DIN Rail Mount
1. Mount your DIN rail. Make sure that the placement of the Pico
unit on the DIN rail meets the recommended spacing
requirements.
2. Hook the top slot over the DIN rail.
3. While pressing the Pico unit down against the top of the rail,
snap the bottom of the unit into position. Ensure DIN latches are
in the up (secured) position.
Pico can be mounted vertically on a DIN rail in the same manner.
3 cm (1.18 in.)
3 cm (1.18 in.)
3 cm (1.18 in.) 3 cm (1.18 in.)