Metrohm 820 IC Separation Center - Manual (Page 35)

2.5 Software-installation
819 IC Detector / 820 IC Separation Center
27
2.4.2 820 IC Separation Center
If an 820 IC Separation Center is included in a modular IC system via an
819 IC Detector then the power supply for the Separation Center is pro-
vided by the 6.2125.090 Cable (see Fig. 12 and Fig. 14).
If the 820 IC Separation Center is controlled separately (see Fig. 13)
then the optionally available 6.2152.000 Power Supply must be used
and inserted in Connection 25 (see Fig. 5).
2.4.3 Column heating
The column heating contained in the 2.820.02X0 versions has its own
power supply. You must connect the 6.2152.010 Power Supply con-
tained in the standard equipment to Connection 24 on the rear panel of
the Separation Center (see Fig. 5).
2.5 Software-installation
The PC program «IC Net 2.3» is required for the operation of 819 IC
Detector and 820 IC Separation Center. This program runs under Win-
dows 2000 and Windows XP operating systems and is installed accord-
ing to Section 1.5.2 of the Instructions for Use 8.110.8283 from the
Metrodata software «IC Net 2.3».
The installation of the instruments is described in Section 6.1.1 / Section
6.1.2 of the Instructions for Use 8.110.8283 from the Metrodata soft-
ware «IC Net 2.3». For the settings of the 819 IC Detector see Section
6.4, for the settings of 820 Separation Center see Section 6.8.
If the Separation Center is to be controlled via the time program of the
detector (see Fig. 12 and Fig. 14) then during installation the Separation
Center must be installed appropriately as 820.02X0 to IC Detector or
820.03X0 to IC Detector
. If the 820 IC Separation Center is to be controlled
separately (see Fig. 13), then it must be installed as 820.0210 to Interface ,
820.0220 to Interface , 820.0230 to Interface , 820.0310 to Interface , 820.0320 to
Interface or 820.0330 to Interface .