Metrohm 820 IC Separation Center User Manual
Page 64
3 Operation
819 IC Detector / 820 IC Separation Center
56
Damping
Electronic damping of the analog output
Selection:
on, off
Damping to reduce disturbing pulsations or a
high noise level. Standard solutions and sam-
ples must both be recorded with damping as
this can influence the peak heights.
Remote lines
Startup value for remote line settings 1
…
8.
Selection:
0
,
1
<SET>
Send current parameters immediately to the
819 IC Detector. Parameters are not stored in
the system file (
*.smt
) as long as the file is not
saved.
Time program
On the
Program
tab of the
819 IC Detector
window a user-defined time
program for the remote output lines of the 819 IC Detector can be en-
tered. This program is started automatically as defined in the
Start mode
window (see Section 4.4.3 of the «IC Net» Instructions for Use) either at
the moment the determination is started (
Start with determination
) or at
the moment the sample is injected (
Start with inject
).
The
Program
tab contains the two following subpages:
Program
Main time program with all program steps.
Remote configuration
Possibility for creation of user-defined remote
commands.