Metrohm 820 IC Separation Center - Manual (Page 71)

3.2 820 IC Separation Center
819 IC Detector / 820 IC Separation Center
63
Time program
The Program tab is only available for a 820.0XX0 Separation Center con-
nected to a 830 IC Interface. The 820 IC Separation Center that is con-
nected to a 819 IC Detector is controlled by the time program of the
detector.
On the
Program tab of the 820.0XX0 Separation Center window a user-
defined time program can be entered. This program is started auto-
matically as defined in the Start mode window (see Section 4.4.3 of the
«IC Net» Instructions for Use) either at the moment the determination is
started ( Start with determination ) or at the moment the sample is injected
( Start with inject ).
First column Time at which program instruction is applied.
Entry range:
0.0 ... 999.9 min
If no time is entered, the program instruction is
applied together with the last instruction with
time entry.
Second column Program instruction (see below).
Third column Parameter for program instruction (see below).
ENABLED Enable program start (a disabled program is
not started).
<Add> Add new program instruction.
<Delete> Delete selected program instruction.
<Verify> Test the time program (error messages are dis-
played if program is wrong).