Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 102)

-102-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect tx-mode
4.2.48.58 loop-protect tx-mode
Command:
loop-protect tx-mode
loop-protect
Loo p protection configuration
tx-mode
Actively generate PDUs
Default:
Enabled
Usage Guide:
To enable tx-mode of Loop protection for specific interface
Example:
To enable tx-mode of Loop protection for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect tx-mode
4.2.48.59 mac address-table learning
Command:
mac address-table learning [secure]
mac
MAC keyword
address-table
MAC table configuration
learning
Port learning mode
secure
Port Secure mode
Default:
Enabled (Auto)
Usage Guide:
To enable learning of MAC address table for specific interface
Example:
To enable learning of MAC address table for GigabitEthernet X/X