110 spanning-tree edge, 111 spanning-tree link-type – Interlogix NS3702-24P-4S Command Line Guide User Manual
Page 131
-131-
4.2.48.110 spanning-tree edge
Command:
spanning-tree edge
spanning-tree
Spanning Tree protocol
edge
Ed ge port
Default:
Non-Edge
Usage Guide:
To enable edge port of CIST Normal Port Configuration for specific interface
Example:
To enable edge port of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge
4.2.48.111 spanning-tree link-type
Command:
spanning-tree link-type auto | point-to-point | shared
spanning-tree
Spanning Tree protocol
link-type
Port link-type
auto
Auto detect
point-to-point
Forced to point-to-point
shared
F orced to Shared
Default:
Auto
Usage Guide:
To configure point to point mode of CIST Normal Port Configuration for specific interface
Example:
To enable point to point mode (shared) of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X